Welcome to GermanyLEDlght.com

EUP20D-1HMC Euchips 20W 350mA 700mA 1ch DALI CC LED Driver

Be the first to review this product

Availability: In stock

€11.28
  • Buy 10 for €10.94 each and save 4%
  • Buy 20 for €10.61 each and save 6%
  • OR

    Quick Overview

    EUP20D-1HMC Euchips 20W 350mA 700mA 1ch DALI CC LED Driver

    EUP20D-1HMC Euchips 20W 350mA 700mA 1ch DALI CC LED Driver

    Double click on above image to view full picture

    Zoom Out
    Zoom In

    More Views

    Details

    EUP20D-1HMC Euchips 20W 350mA 700mA 1ch DALI CC LED Driver

    20W Constant Current DALI-2 Driver EUP20D-1HMC

    EUP20D-1HMC is a 20W AC/DC constant current mode output LED driver featuring the multiple levels

    selectable by DIP switch and complies with DALI standard protocol IEC 62386. EUP20D-1HMC can be

    connected to DALI main controller or Touch DIM to achieve a smooth dimming effect.

    Short Description:

    Item No.:EUP20D-1HMC

    Input Voltage:220VAC-240VAC

    Output Power:20W

    Dim Mode:DALI

    Features

    1. Single channel output, output current level selectable by DIP S.W.

    2. Meet DALI Protocol IEC 62386-207 ed2.0

    3. Support Touch-DIM function

    4. High efficiency up to 85%

    5. Built-in active PFC function

    6. Dimming effect smooth, no flicker

    7. Protections: Short circuit, over load, over Voltage

    8. Suitable for indoor LED lighting application, such as down light, panel light, and so on

    Package Include:

    1 Piece of EUP20D-1HMC Euchips 20W 350mA 700mA 1ch DALI CC LED Driver

    1 Piece of Product's Manual

    EUP20D_1HMC_1120_WGL_1
    EUP20D_1HMC_1120_WGL_2

    EUP20D_1HMC_1120_WGL_3

    Cautions

    1.This product should be installed by qualified personnel.

    2.This product is non waterproof, need to avoid sun and rain.In case of outdoor use, please ensure it is mounted in

    a water proof enclosure.

    3.Good heat dissipation conditions extend product life. Please install the product in a well-ventilated environment.

    4.Please make sure LED power supply output voltage, current is used to meet the product requirements.

    5.Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current.

    Please also ensure that the cable is secured tightly in the connector.

    6.Due to safety concerns, PVC or rubber cord of 0.75- 1.5mm² is recommended for input and output

    terminal(s)(excluding signal terminals). Flat power cord is not suitable.Ensure all wire

    connections and polarities are correct before applying power to avoid any damages to the LED lights.

    7.In case of malfunction, do not repair it yourself.

    CE and RoHS approved

    Additional Information

    Weight 0.2000

    Product Tags

    Use spaces to separate tags. Use single quotes (') for phrases.